-
ASTM D402 Method for Distillation of Cut-Back Asphaltic (Bituminous) Products
ASTM D402 Method for Distillation of Cut-Back Asphaltic (Bituminous) Products1. Scope1.1 This test method covers a distillation test for cut-back asphaltic (bituminous) products.1.2 The values given in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information ...
-
ASTM D391 Standard Specification for Creosote-Coal Tar Solution
ASTM D391 Standard Specification for Creosote-Coal Tar Solution3. Composition and Properties3.1 Creosote-coal tar solution shall be a pure coal tar product derived entirely from tar produced by the carbonization of bituminous coal. It shall be either a coal tar distillate or a solution of coal tar in ...
-
ASTM D391 Standard Specification for Creosote-Coal Tar Solution
ASTM D391 Standard Specification for Creosote-Coal Tar Solution1. Scope1.1 This specification covers creosote-coal tar solution for use in the preservative treatment of wood.1.1.1 Test Method D38 covers the sampling of wood preservatives prior to testing.2. Referenced Documents2.1 ASTM Standards:D38 ...
-
ASTM D347 Tables for Volume and Specific Gravity Correction
ASTM D347 Tables for Volume and Specific Gravity CorrectionASTM D347 Standard Tables for Volume and Specific Gravity Correction for Creosote, Creosote-Coal Tar Solution and Coal Tar1. Scope1.1 These tables have been prepared by the National Institute of Standards and Technology to meet a demand from ...
-
ASTM D168 Standard Test Method for Coke Residue of Creosote
ASTM D168 Standard Test Method for Coke Residue of Creosote9. Report9.1 Report the calculated amount of coke residue to the nearest 0.1 %.10. Precision10.1 Coke Residue, 0 to 2.5 % Range:10.1.1 Repeatability - Duplicate values by the same operator should not be considered suspect unless they differ by ...
-
ASTM D168 Standard Test Method for Coke Residue of Creosote
ASTM D168 Standard Test Method for Coke Residue of Creosote7. Procedure7.1 Heat and adjust the temperature of the uncovered, empty furnace to 950 more or less 20°C. Clean the platinum crucible and cover, place them in the crucible holder, and suspend them in the temperature-adjusted furnace for at least ...
-
ASTM D168 Standard Test Method for Coke Residue of Creosote
ASTM D168 Standard Test Method for Coke Residue of Creosote5. Apparatus5.1 Crucible and Cover - Platinum crucible and cover with dimensions as shown in Fig. 1. The cover shall be tightly fitting, shall have a depth of between 10.0 and 10.2 mm, and shall have a hole 2.0 mm in diameter at its center. The ...
-
ASTM D168 Standard Test Method for Coke Residue of Creosote
ASTM D168 Standard Test Method for Coke Residue of Creosote3. Summary of Test Method3.1 After subjecting the creosote-coal tar solution (oil) under test to the distillation method (Standard A1, Section 2), the weighed residue at 355°C in the distillation flask is thoroughly mixed and a one-gram sample ...
-
ASTM D168 Standard Test Method for Coke Residue of Creosote
ASTM D168 Standard Test Method for Coke Residue of Creosote1. Scope1.1 This test method covers the determination of the coke residue (FIxed carbon) of creosote, coal tar, and creosote-coal tar solutions. As coal tars vary in their coke residue values, the method is therefore not a quantitative index ...
-
ASTM D4 Standard Test Method for Bitumen Content
ASTM D4 Standard Test Method for Bitumen Content9. Calculation9.1 Calculate the bitumen content, as follows:where:A = total mass of insoluble material present, g, andB = total mass of water free sample used, g.9.1.1 Report to the nearest 0.1 %.10. Precision10.1 Estimates of standard deviations for this ...
